Make a statement that sticks with these layered keychain cutters! Designed for dimension and creativity, each set includes multiple pieces that stack together to create bold, eye-catching keychains. Whether you’re going for trendy patterns, seasonal styles, or personalized gifts, these cutters make it easy to build layered designs with serious impact.

Cutter details:

• PLA color may change depending on availability 
• Cutting depth: ~2 mm (Recommended clay thickness: ~3.5-4mm)
• Made with a sharp, 0.4mm edge for clean cuts and minimal cleanup

How to Use:

1. Roll your clay slab on a glossy, flat surface (a ceramic tile works great and is easily found at hardware stores).
2. Dip the cutter in cornstarch to prevent sticking. Dust off any excess with your finger or clay tapper.
3. Press into clay with a slight wiggle side to side, then pull straight up—try not to angle the cutter as you lift.
4. Use a soft, fluffy brush (like a makeup brush) to gently remove excess cornstarch.
5. Fold keychain so it connects on both side,
6. puffing out the ‘strap’ so you add a metal ring / keychain hardware after it is baked. You can insert a small piece or foil to keep the ‘strap’ open during baking. 
7. Baking times may vary by clay brand. I personally bake at 250°F for 60 minutes, but my oven runs hot! I highly recommend checking your oven’s temp with an internal thermometer for best results.

Care Instructions:

• Rinse  with warm water only
• Do not soak and avoid soap, as it can break down PLA over time
• Store in a cool, dry place away from direct sunlight